PA24 door assigned to axis help

[Kilstorm]

Is it possible to assign the Comanche door to an axis to open and close? Theres two parts to the door of the latch and the handle and one would think, a user could assign both features to the same controller as so both are turned on and off but just not sure if it can be done with an axis. I would be using Axis and Ohs for the axis assignment controller.

I would like to connect a push/pull wire to an axis that is connected to my simpit door as so when I open/close the simpit door, it open and closes the door in the sim.

Any help would be greatly appreciated.

[Nick - A2A]

Hi Kilstorm,

This isn't really feasible I'm afraid. The door unlock and open/close animations are programmed to correspond exactly with their associated sound effects, and they're also linked to other aspects of the simulation.

Thanks,
Nick

[Kilstorm]

Thanks Nick. I created a latch and door assignment that works but not attached to my actual door after your post.

https://youtu.be/oFAKF-s5-mY?si=YRNItGNd8oG5BT_-

Happy with the results as it's a physical action to do it (not as labor intensive as actually doing it) but not needing to use the mouse or tablet to achieve the end results.