Albatross in Prepar3D V4?

[degeus]

Hello,
Will your Albatross also work well in Prepar3D V4?
reg.,
Piet de Geus
Netherlands.

[Lewis - A2A]

Hello,

the aircraft was designed for FSX Only. It may port into P3D but obviously this is not supported and we cannot guarantee the product will work.

thanks
Lewis - A2A

[degeus]

Hello Lewis,
If you like it I would be glad to test it for you in Prepar3D V4. Just a plain test and a try-out of animations as written in the readme or manual. I'll install it in the old-fashioned way (directly in the Airplanes-folder.
reg.,
Piet de Geus

[Lewis - A2A]

No need for any testing, its an FSX product. It may or may not port across but obviously is not officially supported.

thanks,
Lewis - A2A

[degeus]

Hello Lewis,
I made a gamble and bought the Albatross. After kidding the installer by just putting a fancy FSX.exe in the install-folder, the installation went smoothly.
Then after doing things as requested in the manual (only guessing how many pumpmovements would be necessary to reach the required air-pressure as there was no real read-out on the gauge) the engine started well and I coud fly the Albatross as if it were a nativer P3d V4 product. Did you get the attachement?
regards,
Piet de Geus

[ianfisher 101]

for those that are interested it also works in v6