You'll need to make sure the 182 for Prepar3D v5 is installed before running this update. If it is, please make sure you haven't manually moved or renamed the installation folder.
Thanks,
Nick
You'll need to make sure the 182 for Prepar3D v5 is installed before running this update. If it is, please make sure you haven't manually moved or renamed the installation folder.
Fuelcro24 wrote: ↑24 May 2020, 05:48Oil or fuel ??ggi wrote: ↑24 May 2020, 03:46 Further to this - I had the fuel leak issue & deleted the log files which cleared the fault. One short flight later and the fuel leak is back. Initially I could repair it, but it returned immediately. I'm not sure if there is a link but I'm also using the F1 GTN 750 and 650 in my setup.
OK i Uninstall, and Reinstall, but where i verifie registry entries?Nick - A2A wrote: ↑25 May 2020, 12:55 It seems the Windows Registry entries for the 182 are not present on your system cro24. Usually this will open happen after uninstallation, but it's also possible that 'registry cleaner' software can corrupt entries. In your case, please can you reinstall the the 182 to make sure that the correct registry entries are present.
Thanks,
Nick
Thanks for the report Gary.
If you're using P3Dv5 Larry, have you tried the hotfix linked above?
Users browsing this forum: No registered users and 6 guests