Hey guys,
I have the following problem: the frequency I set on the Shift+6 popup will not be recognized properly by the Squawkbox frequency selection.
On the screenshot you can see that although 118.80 is selected, Squawkbox says it's 118.79.
I have to use the frequency-lever, then the frequencies will work. This is the same for all frequencies...
I know this may be a problem restricted to Squawkbox, but it's still annoying =P
Can anybody confirm this?
Stefan
Uploaded with ImageShack.us
Shift +6 popup, frequency selection + Squawkbox
Re: Shift +6 popup, frequency selection + Squawkbox
Hi,
i confirm similar problems monitoring frequencies in "shift 6" panel while flying online at IVAO network. It is sometimes impossible to set frequencies like *.800 , *.225 , *.400.
The shift 6 panel sometimel allows only *.405 , *.330.....
i confirm similar problems monitoring frequencies in "shift 6" panel while flying online at IVAO network. It is sometimes impossible to set frequencies like *.800 , *.225 , *.400.
The shift 6 panel sometimel allows only *.405 , *.330.....
P3D v3.2
Addons: FSG2010, REX4 Direct+Soft Clouds, Hifi ASN, PMDG, Dodosim, A2A accusim all, Katana4X, Majestic, ORBX, Fly Tampa, DRZEWIECKI DESIGN, FSDreamteam, Flight Beam,..,..
Addons: FSG2010, REX4 Direct+Soft Clouds, Hifi ASN, PMDG, Dodosim, A2A accusim all, Katana4X, Majestic, ORBX, Fly Tampa, DRZEWIECKI DESIGN, FSDreamteam, Flight Beam,..,..
Re: Shift +6 popup, frequency selection + Squawkbox
I think with the B17 there sometimes is a problem with ILS frequencies not being set correctly, I think this is the same issue
-
- A2A Master Mechanic
- Posts: 3396
- Joined: 02 Aug 2008, 17:04
- Location: San Francisco
Re: Shift +6 popup, frequency selection + Squawkbox
I've seen this happen and if you just continue to cycle through the LSD's of the frequency it
will correct itself. Most often I see something like xxx.740 instead of xxx.750.
I just keep clicking on the Khz setting, 775 800 825 850 875, etc, etc until 750 appears, and it
always does.
Paul
will correct itself. Most often I see something like xxx.740 instead of xxx.750.
I just keep clicking on the Khz setting, 775 800 825 850 875, etc, etc until 750 appears, and it
always does.
Paul
Who is online
Users browsing this forum: No registered users and 20 guests