Hi,
I have a problem setting axis configurations for the aileron/rudder trim using the configurator that came with the A2A mustang (civvy version) When I set the axis they appear in the config utility, but nothing happens when using the controls on the stick. I have the controllers enabled in the P3D config, so it isn't that.
Curiously, I tried setting the axis' for rudder/aileron trim using FSUIPC and this leads to a crash of the entire sim when moving these controls.
For information, I am using a saitek X52 PRO.
Many thanks in advance,
James
Input Configurator not working
Re: Input Configurator not working
Hi James,
A2A P-51 has no release for P3D yet. A2A team explained in a thread in this forum, that they are working on releasing it and the rest of the warbirds for the P3D platform soon.
Cheerz,
Will
A2A P-51 has no release for P3D yet. A2A team explained in a thread in this forum, that they are working on releasing it and the rest of the warbirds for the P3D platform soon.
Cheerz,
Will
Bonanza, Skylane, Skyhawk, Cherokee, Cub, Texan, Mustang, Warhawk, Spitfire, Flying Fortress
- Nick - A2A
- A2A Captain
- Posts: 13808
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Input Configurator not working
Hi James,
Yes, as Will says, the current version of the P-51s (military and civilian) are only supported in FSX. Native 64-bit P3D v4 version of both are currently in development.
Thanks,
Nick
Yes, as Will says, the current version of the P-51s (military and civilian) are only supported in FSX. Native 64-bit P3D v4 version of both are currently in development.
Thanks,
Nick
Re: Input Configurator not working
Hi Guys,
Thanks for the prompt replies - appreciate it. I plan on getting the p3d v4 version when it comes out - though my current issues are with P3D v 3.4 which I thought should work the same way as fsx? I know it used to work on a previous install with P3D v 3 - I know it isn't (officially) supported but just wondering if anyone has a temporary work around, even a way to stop the crash when using FSUIPC.
Thanks,
James
Thanks for the prompt replies - appreciate it. I plan on getting the p3d v4 version when it comes out - though my current issues are with P3D v 3.4 which I thought should work the same way as fsx? I know it used to work on a previous install with P3D v 3 - I know it isn't (officially) supported but just wondering if anyone has a temporary work around, even a way to stop the crash when using FSUIPC.
Thanks,
James
Who is online
Users browsing this forum: No registered users and 25 guests