Engine Selector bug

300Blackout-A2A · Post by **300Blackout-A2A** »

Tonight I figured I'd practice some manual starting. Came across this small bug...

Selecting engine #3 on the selector actually controls engine #4 and vice versa.

Guess all the beta testers have quad-throttles.

mattgn · Post by **mattgn** »

Well, it works absolutely fine on my end. I don't have a quad throttle thingumeebob.
Can you recall exactly what you did to give you this result?

MTFDarkEagle · Post by **MTFDarkEagle** »

How did you set up your axis? I.e. in FSX, A2A-config, FSUIPC?

300Blackout-A2A · Post by **300Blackout-A2A** »

mattgn wrote:Can you recall exactly what you did to give you this result?

Nothing special. Just checked it again this morning, and it is like that every time I load up the aircraft.

How did you set up your axis? I.e. in FSX, A2A-config, FSUIPC?

I'm using the B377 config utility to set up left and right throttles.

Hope that helps.

Post by **some1 - A2A** »

Dagon wrote: I'm using the B377 config utility to set up left and right throttles.

Thanks for the report, this will be fixed.
For now, the #3 and #4 engine selector are reversed when using separate throttles for left and right axis.

lonewulf47 · Post by **lonewulf47** »

Yes, I detected that just after the release

maybe 5 mins too late

In my installation also the red checkmark on throttle #2 doesn't not appear on clicking but nevertheless works correctly.

The A2A Simulations Community