No animations or sound after update

[Eclypse]

Greetings;

I am re-installing the Accu-Sim Spitfire after rebuilding my machine. I find that after running the update I no longer have any animations for the propeller or gauges, lights, or sounds. The aircraft does move like the engine is running though.

I have attempted to un-install via control panel and then manually deleted the A2A files as specified in another thread. However, the result was the same. My installation as follows:

System: Windows 7 64 bit
FSX with Acceleration (no other modifications)

-Install Spitfire
-Install Spitfire Accu-Sim (note at this point the plane runs like a charm)
-Run updater (this detects the Spitfire, downloads the update, and appears to complete normally)

Also note I have the P51 military with Accu-Sim and the C182 with Accu-Sim. I had installed all three and noted the Cessna worked without issue but the P-51 avionics and lights did not work after the update. I have not tried re-installing these after I noted the problems yet.

How can I get my birds back in the air?

[Lewis - A2A]

Hello,

What are your sim settings? All ok in the maint hanger?

Thanks,
Lewis


Sent from my iPhone using Tapatalk

[Eclypse]

Bonjour;

I un-installed FSX, manually deleted any remaining folders, and started completely anew. Not sure what was wrong before but this time my accu-sim Spitfire, Military Mustang, and C182 are all running properly after updating.

Thank you again for such a great product.

[Lewis - A2A]

Great to hear, happy flying

thanks,
Lewis