How do I enable the flight engineer?

BIG, double-deck, four-engine, medium to long range, high altitude, high speed, commercial transport airplane
new reply
Edmeister
Airman
Posts: 44
Joined: 30 Nov 2017, 00:37

How do I enable the flight engineer?

Post by Edmeister »

I know I am new to the B377 forum, so please be patient with me. I have skimmed through the pilots manual, and I pretty much
know how the pop up menu works, as I own the A2A B-17. But somehow I can't find how to enable the flight engineer. Any help
would be greatly appreciated. Thanks in advance, Edmeister :?:

Tomas Linnet
Senior Master Sergeant
Posts: 2285
Joined: 05 Nov 2013, 10:48
Location: Oksboel, Denmark

Re: How do I enable the flight engineer?

Post by Tomas Linnet »

I'll highly recommend that you take the time to read and understand the manual((s) if you have COTS)
Kind Regards
Tomas

Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.

Edmeister
Airman
Posts: 44
Joined: 30 Nov 2017, 00:37

Re: How do I enable the flight engineer?

Post by Edmeister »

Thanks. The popup menu (shift3) was only showing the top two thirds, it was not showing the bottom third of the screen, which is
where the flight engineer is located. I dragged the top of the popup menu toward the top of my computer screen and it appeared.
I hope this helps someone else who might encounter this problem. And I will continue to read the manual. Thanks again, Edmeister :)

new reply

Return to “Boeing 377 Stratocruiser”

Who is online

Users browsing this forum: No registered users and 2 guests