The A2A Simulations Community

B17 start up - says engine 1 fired then engine 2 fired and keeps repeating. Uninstalled and reinstalled 3 times but still same problem. Any ideas please.

Check to make sure Automixture of OFF in the Realism Options.

Scott.

Hello,

just to add to Scott's solution, theres a few other requirements for the FSX settings. These are noted at the beginning of the manual, installed alongside the simulation and located under your start menu >> all programs >> A2A Simulations. If a Win8 user they are on the start screen so long as show all apps is turned on in windows.

thanks,
Lewis

Thanks to you both however despite following both suggestions problem still persists. Any further advice?

Is your auto mixture 100% set to OFF? Also is your FSX updated to SP2?

the only time customers have reported this happening since release has been when auto mixture etc is set to ON and other settings havent seen set correctly.

thanks,
Lewis