I just did a fresh install of CFS3, including patches 3.1 and 3.1a, and then installed FP. While flying a QC I noticed from altitude what looked like a lot of streetlights in a town. On closer inspection it turned out to be missing graphics on many of the houses and buildings, leaving just a white outline (see pic below)
Any idea what I can do to fix this?
Thanks
Missing Buildings after Fresh Install
Missing Buildings after Fresh Install
Last edited by Phalcon51 on 18 Jun 2004, 20:57, edited 4 times in total.
I may not fly worth a damn, but at least I'll look good now in my spectacular flaming death spiral!
- Scott - A2A
- A2A General
- Posts: 16839
- Joined: 11 Feb 2004, 12:55
- Location: USA
- Contact:
-
- Staff Sergeant
- Posts: 304
- Joined: 17 May 2004, 18:22
- Location: North Carolina
Well, I followed Scott's advice from an earlier thread and created different folders so I could run different mods and compare them. I've got CFS3 Stock, CFS3 Modified and CFS3 FirePower. I just ran the CFS2 Stock, which is a fresh install from the disk and then patched to 3.1 and 3.1a and, sure enough, the problem exists there too. I noticed that as the buildings get closer to the foregorund that the roofs or sides of the buildings would appear, and in some cases the whole building would appear. I don't seem to have the problem in the Modified version, but that was based on a completely different install and has been modified with files from Max Devil and Winding Man.
Any ideas? Do I need to start over and reinstall again?
Thanks
Any ideas? Do I need to start over and reinstall again?
Thanks
I may not fly worth a damn, but at least I'll look good now in my spectacular flaming death spiral!
Who is online
Users browsing this forum: No registered users and 3 guests