Some Assigned Controller Switches Not Working

The world's most famous high performance general aviation aircraft
new reply
GaryRR
Staff Sergeant
Posts: 353
Joined: 26 Dec 2020, 22:32
Location: KSEG Selinsgrove, PA

Some Assigned Controller Switches Not Working

Post by GaryRR »

I have my Autopilot and Key Switch mapped to my CH Quadrant. I have it to the left because I have a slide TPM Quadrant on the right and a HCB mounted underneath it. Have CH Yoke also. I used the Input utlility to map the principle autopilot buttons to the detent buttons on the CH Quadrant. My far left two way switch is mapped to AP pitch rocker. Next to that I mapped the key switch. To save buttons, I used P3Ds configurator and set the two sides of the next switch to toggle battery and toggle alternator. They work fine. I tried setting up my remaining switches for pitot heat/prop deice and all lights/panel lights, and beacon/strobe. None of the lights mappings will work on my CH Quadrant. I have been over it and over it. Checked fsuipc, ran the CH Control Manager. P3D reads these switches as live but they are not working in the panel. I am currently running P3D Repair. Does anyone have any ideas?
Thanks.

new reply

Return to “Bonanza "V-Tail"”

Who is online

Users browsing this forum: No registered users and 7 guests