Throttle not closing

[freded]

I am finding that the T-6's throttle is not completely closing during approach and landing.
This results in inability to lose speed and height, causing overshoots.
My hardware is a CH stick and Saitek Pro rudder pedals. I have set them up in the usual way and have not had this problem with other aircraft.
Any suggestions?

Mark

[Lewis - A2A]

Hello,

how far back are you able to move it?

thanks,
Lewis

[Nick - A2A]

Interesting that you mention this Mark, as I've noticed much the same thing, albeit only sporadically. However, I'm sure it's only since installing the T-6. I've not had any success in reproducing the behaviour in a systematic way but sometimes on loading the T-6, the throttle won't close when I close my joystick throttle (it remains about 20-25% open I'd guess).

Wondering if there's some new software processing of throttle inputs in the 6?

What happens if you fully open then close your hardware throttle a few times? Does this fix the issue? It seems to for me.

Cheers,
Nick

[freded]

I've found the culprit.

The next time I started a Flight - sorry 'Scenario' in P3D - I noticed that, when I moved the CH throttle lever, the throttle in the cockpit was jumping from closed to full and back. It wouldn't allow an intermediate position.

I went to the CH Control Manager and re-calibrated the whole thing. Returned to the T-6 but found that the problem was still there.

So I opened Options-Controls-Calibrate Device and ran the calibration. This fixed it.

Hope this helps anyone else with a CH Products yoke.