T-6 Texan Crashing in P3D but not in FSX (CLOSED)

[jtwillia]

I have purchased the T6 for P3D and FSX. I have no problems in FSX but cannot complete a flight in P3D. Detect crashes is on in both sims. I have attempted to complete the same flight 4 times and it crashes about 7 minutes into the flight. I logged the most recent attempt using the FSDuenna application shown here:

http://fs-duenna.com/flights/ShowFlight ... 0knbgctyrI

I have no problem flying this route in the T-6 in FSX. My P3d Settings:



The screenshot below is of the instrument panel a minute before the crash:



I don't know what to do next. Suggestions appreciated.

[jtwillia]

OK, After some further investigation I think we can close this one.

I just completed a T-6 flight from Redding to Santa Rosa in P3D with no problem.

http://fs-duenna.com/flights/ShowFlight ... TgGRkP7Jug

I re-flew the flight leg (NZWK-NZRO) where the T-6 was crashing in P3D the Mooney Acclaim and got a crash at the same spot.

http://fs-duenna.com/flights/ShowFlight ... gbClv4sc3k

I am now suspecting a scenery problem, bad crash box or a non-visible terrain spike, or something like that.

[Lewis - A2A]

Hello,

thanks for keeping us in the loop and letting us know, it does certainly sound like a scenery issue you have there.

thanks,
Lewis