Texan and Prepar3D V3.2

[degeus]

Hello,
Can the two things work together? I would like very much to have the AT-6 Texan for several reasons but will it work in Prepar3D? Ihave version 3.2?
Because the package is not cheap I would rather like to have some certainty before buying.
regards,
Piet de Geus

[wseben]

Hello,
Can the two things work together? I would like very much to have the AT-6 Texan for several reasons but will it work in Prepar3D? Ihave version 3.2?
Because the package is not cheap I would rather like to have some certainty before buying.
regards,
Piet de Geus

i fly the AT-6 in Prepar3D V 3.2 no problem its works great

[lonewulf47]

Hello,
Can the two things work together? I would like very much to have the AT-6 Texan for several reasons but will it work in Prepar3D? Ihave version 3.2?
Because the package is not cheap I would rather like to have some certainty before buying.
regards,
Piet de Geus

Yes, I have done lots of Betatesting using P3D V3.2. So I had no negative experience with V3.2.

[Molly - A2A]

Works great in P3D 3.2 for me as well.

[NavyGuy2007]

Works great for me, I had a cockpit glitch at first but a reinstall fixed it right up.

[Lewis - A2A]

Hello,

so long as you purchase the P3D version you should be good to go.

thanks,
Lewis

[francesco.doenz]

Hm, just realized reading this thread that there should be two downloads, one for FSX and one for P3D? Well downloaded on the products page, there seems only one download option labeled FSX? Did not yet delve into the Texan, just flew it for a maiden flight, seemed working well..is there another version to download and should I expect problems in the futur? For the moment I am still in the process of learning to master the P51 after the spit and P47!?
Thanks again for your inputs!

[Lewis - A2A]

Hello,

you can purchase the P3D products under the P3D section on the A2A store.

thanks,
Lewis

[francesco.doenz]

Thanks for the clarification, on the first day I just jumped into your store and downloaded the texan not realizing there was another store for P3D products! I own now two licences, you more than deserve it for the quality of your products, but not everyone is near retirement to buy two licences, and may be it would be easier to have the products for FSX and P3D side by side....but it's also true that my brain is older and slower to react to new environments....once more thank you very much!!

[zazaboeing]

Does the input configurator works for the T6 on the P3d? I'm only needing this answer to make my decision now.

[Molly - A2A]

It works fine for me.

[zazaboeing]

It works fine for me.

Damn!! I bought it and it DOESN'T work!! What did you do Molleh? It's quite hard to fly the T6, or the Comanche, etc without binding commands to the joystick!

[Lewis - A2A]

Thanks for the clarification, on the first day I just jumped into your store and downloaded the texan not realizing there was another store for P3D products! I own now two licences, you more than deserve it for the quality of your products, but not everyone is near retirement to buy two licences, and may be it would be easier to have the products for FSX and P3D side by side....but it's also true that my brain is older and slower to react to new environments....once more thank you very much!!

Hello,

they are next to each other. The menu on the left for the store notes FS2004, FSX and P3D among other categories.

thanks,
Lewis