Hi Guys,
I use a Go Flight LGTII module.
When I raise/lower the gear in the Commanche it only goes the one position.
The Commanche has a 2 position switch..Is there a workaround to get the switch to move 2 positions to lower the gear?
Dave
Landing Gear
- Nick - A2A
- A2A Captain
- Posts: 13801
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Landing Gear
Hi Dave,
There are "gear up" and "gear down" shortcuts in the Comanche Input Configurator which should do the trick.
Cheers,
Nick
There are "gear up" and "gear down" shortcuts in the Comanche Input Configurator which should do the trick.
Cheers,
Nick
A2A Simulations Inc.
-
- Airman First Class
- Posts: 59
- Joined: 27 Feb 2009, 17:24
Re: Landing Gear
Have tried numerous times with no success..
In the aircraft configurator it has shortcuts for the keyboard but NOT a joystick axis...
at a loss now..
Dave
In the aircraft configurator it has shortcuts for the keyboard but NOT a joystick axis...
at a loss now..
Dave
- Nick - A2A
- A2A Captain
- Posts: 13801
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Landing Gear
Hi Dave,
Not sure it's a good idea to try and use a hardware axis for landing gear although I guess it'd be possible using software like FSUIPC.
It looks like the gear selector on the GF-LGT II panel you mention is a two position switch though. Does the input configurator recognise the switch in both its positions? (The bottom section is not just for keyboard commands; it also works with hardware buttons albeit with some limitations based on the SDKs for FSX/P3D.)
Thanks,
Nick
Not sure it's a good idea to try and use a hardware axis for landing gear although I guess it'd be possible using software like FSUIPC.
It looks like the gear selector on the GF-LGT II panel you mention is a two position switch though. Does the input configurator recognise the switch in both its positions? (The bottom section is not just for keyboard commands; it also works with hardware buttons albeit with some limitations based on the SDKs for FSX/P3D.)
Thanks,
Nick
A2A Simulations Inc.
Who is online
Users browsing this forum: No registered users and 4 guests