Hello to you all,
Since a long time I started to use P3D again and with the use of the Velocity 1 Yoke. I went out flying. I made a route via the GTN 750. As soon as I am on track, I activate the Auto Pilot, choose NAV and GPS on the GTN 750. The plane start to follow the route. Whatever route I choose, the yoke is following as if it is flying with a strong side wind. The yoke never comes back to the Neutral 'zero' position. Have a look at the images.
Can anyone of you tell me what's causing this behaviour.
Thank you and all the best. Best regards,
Ed
Velocity one with prepa3rd 4.5
Re: Velocity one with prepa3rd 4.5
I would start by checking the control centering, and the state of the rudder trim.
Who is online
Users browsing this forum: No registered users and 8 guests