Setting up the switches on the panel of Honeycomb Yoke, I am confused about how I configure properly the Macro by FSUIPC.
Purpose
The exact positions (i.e. ON/OFF) of physical switches on Honeycomb's panel sync with virtual cockpit's switches
Issue
1. After creating MACRO by FSUIPC, the position of switch may not be sync with physical switch on my hardware panel, although it is flipped. For instance, physically flipping BCN switch UP from DOWN triggers VC's BCN switch DOWN from UP, vice versa.
2. The Lvar found in FSUIPC log does not work. For instance, L:BeaconLightSwitch
May I know if I missed something?
Assigning Button & Switch with FSUIPC
-
- Airman Basic
- Posts: 3
- Joined: 28 Nov 2019, 08:07
-
- Senior Master Sergeant
- Posts: 1658
- Joined: 27 Jun 2009, 03:39
- Location: Southern Germany
- Contact:
Re: Assigning Button & Switch with FSUIPC
use LINDA
there is a profile for every A2A addon on Avsim (just google it). It's a lot easier to handle than FSUIPC and it handles the positions itself.
there is a profile for every A2A addon on Avsim (just google it). It's a lot easier to handle than FSUIPC and it handles the positions itself.
- Eric Bakker
- Airman First Class
- Posts: 93
- Joined: 06 Jan 2014, 12:00
- Location: Netherlands
Re: Assigning Button & Switch with FSUIPC
Alternatively, you can use the YokeInput program supplied by Honeycomb/Aerosoft.
It has templates for the switches of all A2A GA planes, and easy to use.
It has templates for the switches of all A2A GA planes, and easy to use.
Bonanza - T6 Texan - Constellation - PA-24 Comanche - PA-28 Cherokee - C182 Skylane - C172 Trainer - Spitfire - Accu-Feel
| [email protected] | RTX2080ti-11Gb | Win10
| [email protected] | RTX2080ti-11Gb | Win10
Who is online
Users browsing this forum: No registered users and 11 guests