Changes VFR Squak from 1200 to 7000?

[Boon1986]

Hey.
What must i do to change the standard VFR squak from 1200 to 7000?
I mean push the VFR button and can read 7000
Best Regards Daniel

[Molly - A2A]

This is from the real Bendix/King manual

VFR Button

Momentarily pressing the VFR button will enter a pre-programmed VFR code, typically 1200, in the code window. Pressing and holding the VFR button for two seconds will cause the last active code to be displayed. During installation, it may be desired to set the default VFR code to a code other than 1200. The VFR code is programmed by the following sequence:

1. Place the unit in standby.
2. Enter the desired VFR code with the ident code pushbutton
switches.
3. Depress the “VFR” pushbutton while holding the “IDT”
pushbutton in its depressed position.

[Boon1986]

have found it thust in this moment SRRRRYY for my stupid

[Fabo]

How would one do this, though?

3. Depress the “VFR” pushbutton while holding the “IDT”
pushbutton in its depressed position.

[KaptajnKjuk]

Push the the IDT button with the mouse, move the cursor away and then realese the mouse button. This usually "sticks" a button in FSX. Then press the VFR button

[Nico081]

Push the the IDT button with the mouse, move the cursor away and then realese the mouse button. This usually "sticks" a button in FSX. Then press the VFR button

You also can use the right mouse button to depress IDT. This holds IDT depressed until you depress VFR with your left mouse button.