The A2A Simulations Community

Plus it is mostly yellow as God intended fer a Cub...

Don

Hey YoYo I am very fond of those "dirty" paints, especially the red "Bushwhacker". Would love a conversion.

Donald Traill

The 685 multi pack has a typo preventing the Red livery from showing up in P3D. Instead of (tailnumber)_Red it should be (tailnumber)-Red

Donald Traill

Can 32 bit or old paints be used with the V4 version of the Cub? If not could we get a separate paint thread?

Thanx

Donald

The Commanche has altitude hold but not pitch hold. So it can only be used during cruise, not climb or tracking an ILS. Altitude hold is on the yoke. But you must keep the plane in trim manually to mantain altitude. The autopilot will help you by beeping when it is out of trim and indicating whether...

I can't find an owner's manual anywhere in the VC. In other A2A planes I like clicking on it to quickly check my cabin temp.

Donald

One question... 25" for descent? I use 25" to climb... typo?

Donald

There used to be an option in the .ini file that would corect this. I think it was link VOR. I remember this from the Mustang civilian early days.

Donald

Pretty please can this be a sticky???

Donald

I think I have narrowed it down to not being a problem with the airplane. The GTN 750 appears when I use the P3D icon but not when I use Flyinside.

Donald

I downloaded the latest installers and my GTN 750 works in other aircraft.

Apparently I have previous files floating around, even though I deleted my documents/a2a folder I get the notification when installing that I have other a2a aircraft installed there when installing my first aircraft.

Donald

Since updating to P3D 4.3 my GTN 750 has disapeared from the VC of my Cherokee. My shift three options are always no gps, 295 and 400. When I open the aircraft configurator it says I have selected the GTN 750. I have tried setting it back to default then back to GTN. Also I have run the tool in admi...

EDIT: I figured it out, the chain should end at simobjects if the planes are installed in the default location.


Where do I end the link? At Prepar3d V4 addons, A2A, Simobjects or airplanes?

Thanx for your reply

I installed the Texan in the default location for P3D V4. I scanned for models and it did not show up on the substitute aircraft list and I did not see anyone else in a Texan who wasn't mismatched.

How do you get A2A planes to work with JoinFS?

Thanx in advance

Donald

I have the Skylane in mind, but it seems like this applies generally to prop aircraft. The manual for the 182 says: Recommended Lean 50° Rich of Peak EGT Best Economy Peak EGT Best Power 125° Rich of Peak EGT Isn't the peak EGT getting as high as you can on the indicator? I can do that. How c...