The A2A Simulations Community

Good Morning,

As mentioned above, every time I load the Bonanza, it loads with the gear retracted. I have tried to reset the plane to new, even gone into slew mode to get the gear down, and the flight as such, and then the next time I start a flight, the gear is up again. Any ideas?

That's how I have it mapped but when I moved to FSUIPC I disabled all controllers in FSX as instructed so that you don't have FSUIPC commands stepping on FSX mapped ones and vice versa. Disabling controllers within FSX also kills the axis assignment that was set up in the configurator. WHat I wound ...

I have all my controls managed through FSUIPC which means I have them turned off in FSX. Now prior to this I had the axis for the turbo working fine through my CH setup, however now that I have moved to FSUIPC I cannot seem to map the axis. Surely I cannot be the only one who has had this issue, is ...

I am in fact reducing rpm and boost to cruise settings but the thing still rattles quite a bit. What concerns me are the gauges fluctuating. The boost gauge needle fluctuates a good half psi in either direction. I've seen that the update make the bird more shaky which I do have installed. Just makin...

Good catch. I'm typing on an iPad which can produce some weird typos. Basically this bird is rattling more than videos that I've watched so I'm assuming something is broken. Did I throttle up too early before everything warmed up? Did I give it throttle too quickly? Next time I load it up I need to ...

Sadly I don't give this beauty the same amount of attention as some other aircraft so I'm not sure if the amount of shaking I get in the cockpit is normal. Once I throttle up for takeoff I get lots of shaking and fluctuating of the needles. I assume this is due to the engine running rough but even a...

I think it's working properly and I'm just used to another Mustang that I've been using in X-Plane that isn't quite as realistic, which has insane amounts of tailwheel movement.

Came here to say I'm having the same issue. Fresh install of FSX:SE, fresh install of the P-51, Ran the latest update, controls are unlocked. Now the question is with the stick back and the tail wheel locked, is it supposed to be steerable as well or is the travel merely locked at 6 degrees as state...

https://fbcdn-sphotos-a-a.akamaihd.net/hphotos-ak-prn1/q71/s720x720/994358_10151699184974032_196984516_n.jpg https://fbcdn-sphotos-g-a.akamaihd.net/hphotos-ak-ash3/q71/s720x720/1175070_10151701430264032_2133448734_n.jpg https://fbcdn-sphotos-f-a.akamaihd.net/hphotos-ak-ash3/q71/s720x720/539634_1015...

This is my first request for paints ever I think. I enjoy older paint schemes that are more on the simpler side so here are two that I think are representative of the typical C172s I see. Would these be hard to do?

I read on another forum from a pilot who flies the 172 in real life that it is "very floaty" when flaring.

I originally came for the FS9 warbirds and I'm thrilled to see the 172. I bought the Cub and while I like it, it's a bit too simple and slow for me, perhaps I haven't put it in the right setting yet. Anyway, the 172 is incredible, instant buy for me. Love getting out of the cockpit of an airliner an...

34 people have looked at this and not even a single guess as to the problem??

I have an issue with one of the paints included with the jug, a whole side of the fuselage shows up as differently colored large pixels. Enclosed are some pics. Thank you for your help. http://i142.photobucket.com/albums/r101/deimos256/j2.jpg http://i142.photobucket.com/albums/r101/deimos256/j1.jpg

is this for the standalone version only? i purchased the old fs9 package a very long time ago and would love to be able to use it in FSX