v1.2.0 Update for Accu-Sim Comanche 250 MSFS

Today we’re pleased to release an update to v1.2 for the Accu-Sim Comanche 250. Included in the change list is a fix for the waggling wings some customers were experiencing with low FPS. Our Comanche is keen to be flown, but she wasn’t actually supposed to flap her wings.

To install version 1.2, please click the “Comanche Check for Updates” shortcut in the “A2A Simulations” folder in the Windows start menu.

Version 1.2.0 Changes

  1. Improved wing flex animation to work properly at all framerates and fixed bug that caused extreme wing flex movements at around 20 fps
  2. Improved cockpit glass transparency for better clarity, particularly with high-end VR headsets
  3. Added support for ambient sounds with door and windows opened and during walkaround
  4. Added support for mono Bluetooth headsets with low sampling rate
  5. Added function to EDM 830 to reset fuel used by holding both buttons on USD screen (accessed via right click and hold on either button)
  6. Fixed shock cooling warning not showing when it should on EDM 830
  7. Added additional protection against false prop strikes caused by terrain errors
  8. Reduced lift provided by flap gap seals
  9. Additional tuning of ground physics
  10. Added tablet brightness slider to tablet settings
  11. Improved handling of magneto starter shortcuts
  12. Added starter button response to magneto events for improved hardware panel compatibility
  13. Added function to remove registration placard in cockpit via mouse click
  14. Removed clicking sound from GPS and COMM radio volume knobs
  15. Fixed ADF on/off sound
  16. Reduced size of click spots to hide and show yokes
  17. Improved smoothness of cabin door animation
  18. Fixed generator bug where it would not come back online if all electrics were off, idle was reduced to shut it off then increased to turn it back on again
  19. Added ability to fix landing lights in the walkaround
  20. Fixed fuel quantity gauges tooltips
  21. Fixed small issues in external model, left windshield frame, elevator trim rivets and nose wheel steering cylinder animation
  22. Increased amount of yoke deflection required to disconnect autopilot
  23. Fixed yoke movement turning off autopilot master switch rather than disconnecting autopilot
  24. Added overhaul confirmation to maintenance page of tablet
  25. Fixed cockpit persistence and loading with cold and dark and phases
  26. Fixed engine temperature not being properly saved with cold start
  27. Fixed event flood associated with com channel spacing
  28. Changed centre of gravity units to inches rather than percent on tablet fuel and payload page
  29. Fixed issue where rudder could get damaged too easily when not in use
  30. Added support for MSFS auto-rudder function
  31. Improved compatibility with MSFS parking brake event so it no longer interferes with toe brakes operation
  32. Updated gauge glass rendering
  33. Fixed navigation lights key shortcuts
  34. Added prop lever choice to persistent per-livery state
  35. Tuned yoke animation
  36. Fixed door opening in multiplayer
  37. Fixed cabin door latch animation
  38. Tuned balance of beacon motor sound effect
  39. Fixed screws position on the right main fuel tank
  40. Amended references to recommended maximum landing gear operating speed on page 35 of the pilot’s manual

Thanks as always to our community for the feedback and just a note to say that we’re still investigating the issue with tablet screen interaction for VR users who have the SU13 beta installed.


– A2A Simulations