AP Mode LVAR control
AP Mode LVAR control
I am trying to set up my Saitek Multipanel Autopilot heading button to select through the AP Mode options ( ST HD TRK) but no matter what i do i cannot seem to get it to work. I'm using Spad.neXt and have set up my controls, radio and switch panels and the last thing i have been trying to get to work is the AP. Has anyone managed to get this working with Spad.neXt?
Re: AP Mode LVAR control
"AP Mode" lvar is a only read one.
Use the following lvars:
"ApMaster" to switch on-off the autopilot.
"ApModePushSwitch" momentary push button to change mode.
"ApDisconnectSwitch" momentary push button to disconnect AP.
"ApAltSwitch" momentary push button to altitude hold connect/disconnect.
Arturo.
Use the following lvars:
"ApMaster" to switch on-off the autopilot.
"ApModePushSwitch" momentary push button to change mode.
"ApDisconnectSwitch" momentary push button to disconnect AP.
"ApAltSwitch" momentary push button to altitude hold connect/disconnect.
Arturo.
Re: AP Mode LVAR control
Thanks
Have managed to get both heading and Alt to work ( although for some reason they take a double push of the button to work).
Have managed to get both heading and Alt to work ( although for some reason they take a double push of the button to work).
Re: AP Mode LVAR control
It make sense. You are toggling the variables. If it is 0, you push (and release) and goes to 1. Push (and release) and goes to 0.zkiwi wrote:... for some reason they take a double push of the button to work).
But those buttons in the comanche are 1 while push, only while push. If you release the button, goes to 0.
So. you need to push twice to make the variable go to 1 and then to 0.
You will have to change something in the setup software, or fsuipc... or whatever you are using
Arturo.
- Nick - A2A
- A2A Captain
- Posts: 13808
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: AP Mode LVAR control
Chiming in rather late here guys, but the correct way to use the L:Var "L:ApModePushSwitch" is to SET it to 1 on press and SET it to 0 on release. This should avoid the need for the double press. This can be done easily with FSUIPC, but I'm not familiar with SPAD.neXt.
The same goes for "L:ApAltSwitch" I believe.
Cheers,
Nick
The same goes for "L:ApAltSwitch" I believe.
Cheers,
Nick
Who is online
Users browsing this forum: No registered users and 34 guests