Hello
Pls help me. End of the road here.
For the past many days ,I been trying all my best to manual and auto start my
civilian P-51 Mustang and the answer is no no no.. and this is really stressful .
I had follow a few tutorials from the nets to the last letter but this ladies is giving me the cold shoulder.
take airs here , that also keep me wondering has my install gone south.
This is my install order for the P-51 mustang
1. wop3_p51_civ.zip from the flightsim store Order No:#FSS0278157
2. wop3_p51_accusim.zip
3. A2A_Update-10_12_17.zip from the A2A site
i did'nt install the previous accusim_core_update_v1.6.EXE.
Could this be the caused of her refuses to start.
regards.
ricky
old pain starting up the civilian P-51 Mustang
- Lewis - A2A
- A2A Lieutenant Colonel
- Posts: 33320
- Joined: 06 Nov 2004, 23:22
- Location: Norfolk UK
- Contact:
Re: old pain starting up the civilian P-51 Mustang
Hello,
the install looks fine. However can you give us better information about what the issue is.
Does she start using auto start under the shift + 3 menu?
thanks,
Lewis
the install looks fine. However can you give us better information about what the issue is.
Does she start using auto start under the shift + 3 menu?
thanks,
Lewis
A2A Facebook for news live to your social media newsfeed
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
Re: old pain starting up the civilian P-51 Mustang
Hi Lewis,
Thanks for quick reply.
yes, using shift +3 auto start .it crank awhile, throttle was set at 10% then it went quiet.
next i proceed on to the compression test page, all the tabs were showing green, it mean things are in working order
however it is not going to start even with the auto start. weird..
I am using chaseplane but i don't think the software is the cause of it as it have always been doing fine with my other software like ops, rax weather engine.
Thanks again for good and prompt support
ricky
Thanks for quick reply.
yes, using shift +3 auto start .it crank awhile, throttle was set at 10% then it went quiet.
next i proceed on to the compression test page, all the tabs were showing green, it mean things are in working order
however it is not going to start even with the auto start. weird..
I am using chaseplane but i don't think the software is the cause of it as it have always been doing fine with my other software like ops, rax weather engine.
Thanks again for good and prompt support
ricky
- Lewis - A2A
- A2A Lieutenant Colonel
- Posts: 33320
- Joined: 06 Nov 2004, 23:22
- Location: Norfolk UK
- Contact:
Re: old pain starting up the civilian P-51 Mustang
Hello Ricky,
hows the fuel in the aircraft?
Also how are you loading the aircraft flight into FSX?
thanks,
Lewis
hows the fuel in the aircraft?
Also how are you loading the aircraft flight into FSX?
thanks,
Lewis
A2A Facebook for news live to your social media newsfeed
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
- Skycat
- Senior Master Sergeant
- Posts: 2195
- Joined: 11 Nov 2006, 16:15
- Location: Great Falls Army Air Base, Montana
Re: old pain starting up the civilian P-51 Mustang
Make sure that "automixture" is not checkmarked in your FSX realism settings. Begin your FSX session by loading a default aircraft first. Next, load your P-51. Do a complete overhaul in the maintenance hangar, just to be sure you have a fully healthy airplane for your first startup. Check the fuel levels. Use the A2A panel's auto start option for your first startup -- it is essentially bullet-proof if the sim is configured correctly. Run the engine to get your temperatures up, then properly shut down the plane. You should now be able to restart it easily using a manual procedure.
Pax Orbis Per Arma Aeria
Re: old pain starting up the civilian P-51 Mustang
Hi Skycat
Your instruction has helped and the P-51 civilian is now all up and running. Oh .. it's been a long long time
i didn't get to hear the aircraft sound, you make it happens. It's really wonderful.
Thanks for the BIG help Bro and Lewis as well for your quick response.
regards.
ricky
Your instruction has helped and the P-51 civilian is now all up and running. Oh .. it's been a long long time
i didn't get to hear the aircraft sound, you make it happens. It's really wonderful.
Thanks for the BIG help Bro and Lewis as well for your quick response.
regards.
ricky
- Skycat
- Senior Master Sergeant
- Posts: 2195
- Joined: 11 Nov 2006, 16:15
- Location: Great Falls Army Air Base, Montana
Re: old pain starting up the civilian P-51 Mustang
I'm happy it worked out for you.
Pax Orbis Per Arma Aeria
Re: old pain starting up the civilian P-51 Mustang
Hiya,
- Autostart via A2A menu works
- In above mentioned scenerio it works
- Cold and dark via A2A menu en then following the checklist: does not work. Prop turns yet the engine will not fire/start
What am i doing wrong or forgetting?
Cheers,
Marcel
BTW: Cold and dark start with my T-6 and Spitfire does work. (all in FSX)
Must confess i've the same problem, i can not get my P-51D started any more from cold and dark.Skycat wrote:Make sure that "automixture" is not checkmarked in your FSX realism settings. Begin your FSX session by loading a default aircraft first. Next, load your P-51. Do a complete overhaul in the maintenance hangar, just to be sure you have a fully healthy airplane for your first startup. Check the fuel levels. Use the A2A panel's auto start option for your first startup -- it is essentially bullet-proof if the sim is configured correctly. Run the engine to get your temperatures up, then properly shut down the plane. You should now be able to restart it easily using a manual procedure.
- Autostart via A2A menu works
- In above mentioned scenerio it works
- Cold and dark via A2A menu en then following the checklist: does not work. Prop turns yet the engine will not fire/start
What am i doing wrong or forgetting?
Cheers,
Marcel
BTW: Cold and dark start with my T-6 and Spitfire does work. (all in FSX)
-
- Senior Master Sergeant
- Posts: 2286
- Joined: 05 Nov 2013, 10:48
- Location: Oksboel, Denmark
Re: old pain starting up the civilian P-51 Mustang
Does the A2A auto start work OK?
Kind Regards
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
- Nick - A2A
- A2A Captain
- Posts: 13805
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: old pain starting up the civilian P-51 Mustang
Yep, exactly what I was going to ask.Tomas Linnet wrote:Does the A2A auto start work OK?
Thanks,
Nick
-
- Senior Master Sergeant
- Posts: 2286
- Joined: 05 Nov 2013, 10:48
- Location: Oksboel, Denmark
Re: old pain starting up the civilian P-51 Mustang
Haha, not easy to the first guy to answer with Lewis and yourself constantly scanning the forums
Kind Regards
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Re: old pain starting up the civilian P-51 Mustang
Hi Nick,
The only time i can not get the engine started, when pressing the "cold and dark state" (SHIFT+3) and then follow the checklist (SHIFT+2) to the letter.
Auto-mixture is unchecked, as in mentioned before and in the manual.
Marcel
Yes, that's what i mean with my first lineNick - A2A wrote:Yep, exactly what I was going to ask.Tomas Linnet wrote:Does the A2A auto start work OK?
Thanks,
Nick
The only time i can not get the engine started, when pressing the "cold and dark state" (SHIFT+3) and then follow the checklist (SHIFT+2) to the letter.
Auto-mixture is unchecked, as in mentioned before and in the manual.
Marcel
-
- Senior Master Sergeant
- Posts: 2286
- Joined: 05 Nov 2013, 10:48
- Location: Oksboel, Denmark
Re: old pain starting up the civilian P-51 Mustang
I’m afraid that is good news.....then it must be a problem with the way you are trying to start the engine
For how longtime do you prime? And what ambient temperature du you have?
Do you have fuel pressure before priming?
For how longtime do you prime? And what ambient temperature du you have?
Do you have fuel pressure before priming?
Kind Regards
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Re: old pain starting up the civilian P-51 Mustang
Hi,
Prime = 4 seconds
Ambient Temp = 15 deg
Fuel pres = 18 PSI
Marcel
Was afraid of that answerTomas Linnet wrote:I’m afraid that is good news.....then it must be a problem with the way you are trying to start the engine
For how longtime do you prime? And what ambient temperature du you have?
Do you have fuel pressure before priming?
Prime = 4 seconds
Ambient Temp = 15 deg
Fuel pres = 18 PSI
Marcel
- guillaume78150
- Staff Sergeant
- Posts: 467
- Joined: 08 Oct 2015, 06:07
- Location: North Burgundy
- Contact:
Re: old pain starting up the civilian P-51 Mustang
Check :
Carburator air : on
Mixture : idle cut-off
Fuel cut-off : on
Throtlle : 10/15 %
Tank selector : selected tank with fuel… (I know but I tried to start on an empty tank and it does not work well…)
If engine cold, crank the engine and count 6 blades before engaging magnetos.
When the engine starts coughing, help by priming once more. Once started, mixture on "Run".
Carburator air : on
Mixture : idle cut-off
Fuel cut-off : on
Throtlle : 10/15 %
Tank selector : selected tank with fuel… (I know but I tried to start on an empty tank and it does not work well…)
If engine cold, crank the engine and count 6 blades before engaging magnetos.
When the engine starts coughing, help by priming once more. Once started, mixture on "Run".
Who is online
Users browsing this forum: No registered users and 28 guests