I did a quick search, but I could not remember where I saw this thread a while ago...
So, what's the best way (especially with the newest update) to start the P-51 when the OAT is in the 20's or even teens?
it's cold up here in New England!
I can't seem to get the MIL/CIV started without flooding it, or killing the battery...
Starting in the Cold
-
- Airman
- Posts: 32
- Joined: 24 Mar 2016, 07:43
- Piper_EEWL
- Chief Master Sergeant
- Posts: 4544
- Joined: 26 Nov 2014, 14:14
- Location: Germany
Re: Starting in the Cold
What I usually do is prime for 4-5s. Then turn the primer off an switch the starter on. Count six blades and then the mags. If she doesn't fire I just add more primer while the starter is turning the engine. Once she starts "coughing" I turn the primer off and she starts. Seems to work if it's not too cold.
Don't forget to give the starter a brake after about 30s.
Happy flying
Don't forget to give the starter a brake after about 30s.
Happy flying
B377&COTS, J3 Cub, B-17G, Spitfire, P-40, P-51D, C172, C182, Pa28, Pa24, T-6 Texan, L-049&COTS, Bonanza V35B
-
- Airman
- Posts: 32
- Joined: 24 Mar 2016, 07:43
Re: Starting in the Cold
Piper_EEWL wrote:What I usually do is prime for 4-5s. Then turn the primer off an switch the starter on. Count six blades and then the mags. If she doesn't fire I just add more primer while the starter is turning the engine. Once she starts "coughing" I turn the primer off and she starts. Seems to work if it's not too cold.
Don't forget to give the starter a brake after about 30s.
Happy flying
Yeah, that's pretty much what I end up doing. So, as long as the blades are turning, the engine won't flood with the primer on?
- Piper_EEWL
- Chief Master Sergeant
- Posts: 4544
- Joined: 26 Nov 2014, 14:14
- Location: Germany
Re: Starting in the Cold
Well I wouldn't say that you can't flood the engine when priming while it's spinning but you'll get an indicator if it's to little fuel. At temperatures below 25F priming 4s won't be enough in my experience.
B377&COTS, J3 Cub, B-17G, Spitfire, P-40, P-51D, C172, C182, Pa28, Pa24, T-6 Texan, L-049&COTS, Bonanza V35B
- DHenriques_
- A2A Chief Pilot
- Posts: 5711
- Joined: 27 Mar 2009, 08:31
- Location: East Coast United States
Re: Starting in the Cold
The electric primer in the 51 is EXTREMELY potent. On a cold start, 4 seconds should do it normally but if very cold might not. Kick it over and resist the temptation to advance the throttle. Leave it at around 1 inch or the start position and as the blades engage be ready to prime in 1 second shots with a second between. If no start in 15 seconds shut down and retry in a few minutes.Piper_EEWL wrote:Well I wouldn't say that you can't flood the engine when priming while it's spinning but you'll get an indicator if it's to little fuel. At temperatures below 25F priming 4s won't be enough in my experience.
Usually you can get a start using this procedure.
The main thing is start it on the primer then quickly go to RUN on the mixture.
Dudley Henriques
- Piper_EEWL
- Chief Master Sergeant
- Posts: 4544
- Joined: 26 Nov 2014, 14:14
- Location: Germany
Re: Starting in the Cold
Thanks for the input Dudley. Yes that's what I meant to say. Prime 4-5s when cold and then add some primer while the engine is turning on the starter if it doesn't start.
Happy flying
Happy flying
B377&COTS, J3 Cub, B-17G, Spitfire, P-40, P-51D, C172, C182, Pa28, Pa24, T-6 Texan, L-049&COTS, Bonanza V35B
Who is online
Users browsing this forum: No registered users and 32 guests