The A2A Simulations Community

I have the X-52 and feel like I have a decent set-up with it.

However I have nothing mapped to the two twisty-things on my throttle quadrant, and I would like 2 more controls available for the Mustang. Functionality on other aircraft isn't a big concern.



On a related note, I've been pondering this and had hoped you guys would have some input.... T1 through T6 on my stick quadrant are a little wonky, but I'm not sure how to switch it.

T1 - A/P Master
T2 - Gear Up/Down
T3 - A/p Alt Hold
T4 - Flaps Up Increments
T5 - A/P Heading Hold
T6 - Flaps Down Increments

I feel like I should makes flaps up/down on one switch and do the same with my gear. But then I would have to cut out my heading hold and I really like having those commands off the keyboard.


Thanks in advance.

What do you have assigned to your throttle and the top buttons on your stick? I currently have my gear assigned to E on the throttle, its a little easier have the gear assign to E than T1 and T2. Did you know that you assign funtions to the 3 buttons below the MFD?

Mike

_________________

If you still have good dials on the throttle, those twisty things, you could bind one of them to the prop pitch. I used to do that but my dials have lost some accuracy, and dont get full range they go 3% to 97% even after recalibration and are extra sensitve, so I re-bound prop to E and D. It's not ideal but it's the only complaint of my 5 year old X52 pro. Oh I forgot my mouse control "stick" is buggered too. So it's still been 5 year on one stick so ya still happy.

_________________