The A2A Simulations Community

Hello I purchased Accu-Feel from the A2A web site yesterday.

After running the installer for FSX-SE, I do see a new Add On menu command, and I am able to set and save configuration parameters successfully.

I tested Accu-Feel using Carenado's Beech V35 and I noticed that I do not have the following effects despite sliders being set to max, or near max:

~ No flap deploy noise
~ No "loose" cabin noise
~ No gear deploy noise
~ No brake noise
~ Very little tire squeal noise on landing
~ Odd side loading behavior, aircraft "feels" as if it wants to "pitch-over" during take-off roll (reducing the side-loading to 5% helped)

Have similar issues been reported?

I'm not sure it's relevant, but I am running FlyInside and using Oculus Rift.

I have not yet tested other aircraft, nor have I tested outside of FlyInside / VR headset.

I will report back test results this evening.

Meanwhile, if you have any suggestions, I would greatly appreciate it.

I have the A2A Cherokee, and I love the effects that aircraft has; so I was hoping Accu-Feel would improve my flight sim experience with other aircraft.

Respectfully,
Chris in Corpus Christi, Texas

Hello,

first thing to check would be to see if you have ran the latest Accu-feel v2 update here;
http://a2asimulations.com/forum/viewtop ... 87&t=34173

thanks,
Lewis