P40 in P3D

Honest, reliable, iconic American fighter
new reply
danb12
Staff Sergeant
Posts: 373
Joined: 10 Jun 2012, 09:02

P40 in P3D

Post by danb12 »

Hi all,

I have installed the P-40 into P3D, and it all seemed to install fine.

I have started the engine etc and taxied and it seems to sink into the ground and float and smash to pieces in the hangar.

I have tried several airfields and have the same problem.

Does anyone have any ideas?

Thanks
Dan

P.S I know that the P4- etc are not designed for P3D but hoped to install into P3d as many have... :(

User avatar
LZ-WIL
Master Sergeant
Posts: 1370
Joined: 23 Jun 2015, 13:59
Location: LBSF

Re: P40 in P3D

Post by LZ-WIL »

Hi,

Set "mesh complexity" under Settings to 10 and test it.
Check this article: http://a2asimulations.com/forum/viewtop ... 94&t=50497

Cheerz,
Will
Bonanza, Skylane, Skyhawk, Cherokee, Cub, Texan, Mustang, Warhawk, Spitfire, Flying Fortress

danb12
Staff Sergeant
Posts: 373
Joined: 10 Jun 2012, 09:02

Re: P40 in P3D

Post by danb12 »

Hi Will,

Thanks a lot... I will look into this. I did manage a flight last night without the issue but didn't do anything different...

Thanks for the heads up!

Dan

new reply

Return to “P-40 Warhawk / Tomahawk”

Who is online

Users browsing this forum: No registered users and 8 guests