Problems with Spitfire in P3D 3.4

Post any technical issues here. This forum gets priority from our staff.
new reply
BernieS
Airman Basic
Posts: 7
Joined: 19 Aug 2012, 13:00

Problems with Spitfire in P3D 3.4

Post by BernieS »

I have installed the Spitfire & AccuSim directly into P3D 3.4. The installation ran without problems, as did the subsequent updates.

However - shift7 tells me that I can only enter the hangar when I am on the ground with the engine off - which I am.

Shift4 allows me to update some of the quantities, but not fuel - which is at 100% despite the fuel gauge in the cockpit showing empty.

And, despite following the start-up flow carefully the engine doesn't start - which may be because I don't hear the starter cartridge going off.

The Piper Cub appears to be working perfectly for what it's worth. And yes, I do know that that is a relatively simple simulation, wheres the Spitfire is a very complex one.

So - has anybody managed to get the Spitfire working correctly in 3.4 - & if so, what steps did you take to make it happen?

Thanks,

Bernie
Image
Image
Image
Image

User avatar
bladerunner900
Senior Master Sergeant
Posts: 1991
Joined: 17 Aug 2008, 14:59
Location: South Wales

Re: Problems with Spitfire in P3D 3.4

Post by bladerunner900 »

Hello sir.

Have a read of this thread and all will be made clear. Pay particular attention to the requirement for at least one P3D native GA model from A2A.
http://www.a2asimulations.com/forum/vie ... 78&t=58285

Cheers.
Steve

BernieS
Airman Basic
Posts: 7
Joined: 19 Aug 2012, 13:00

Re: Problems with Spitfire in P3D 3.4

Post by BernieS »

Problem solved!

I uninstalled it, reinstalled, ran all of the latest updates & now it appears to be working fine.

Now - to try the P51!!

Thanks for the help.

Bernie
Image
Image
Image
Image

User avatar
bladerunner900
Senior Master Sergeant
Posts: 1991
Joined: 17 Aug 2008, 14:59
Location: South Wales

Re: Problems with Spitfire in P3D 3.4

Post by bladerunner900 »

That is good news. I could do with some at the moment.

new reply

Return to “Spitfire MkI/II Tech Support”

Who is online

Users browsing this forum: No registered users and 11 guests