Page 1 of 1

Problem with the new Accsim update with the Spitfire

Posted: 21 Jul 2014, 06:42
by birdie33
I have a problem with the new Accu-sim update 07/15/2014.
I have 6 A2A Accu-sim planes and the update works fine and has located and updated 5 of them.
When it tries to update the Spitfire it starts to down load the update but then stops with the following error message:-
The Down loaded file "Spitfire 1.0 to 2.0.wyu failed the adler 32 validation.
I have uninstalled and reinstalled the Spitfire and Accusim but continue to get the same error message.
Can any one help please?
Kindest regards
Paul Bird :cry:

Re: Problem with the new Accsim update with the Spitfire

Posted: 21 Jul 2014, 07:33
by Lewis - A2A
Hello Paul,

I've passed this along to Scott so he can check his bits. But can you please also check you are right clicking on the installer and selecting run as admin just in case your system security is having an effect.


Sent from my iPhone using Tapatalk

Re: Problem with the new Accsim update with the Spitfire

Posted: 21 Jul 2014, 07:47
by Scott - A2A
Paul,

Physically remove these directories:

A2A / Spitfire
SimObjects / Airplanes / WoP3_Spitfire

Then install the:
1. Spitfire
2. Spitfire Accusim
3. 7/15 update

Scott.

Re: Problem with the new Accsim update with the Spitfire

Posted: 21 Jul 2014, 12:55
by birdie33
Hi Scott
Thanks for your prompt response.
I carried out your instructions but when running the new update the spitfire was not found so I deleted again to your requirements. I had used the version 2 Accusim,
I reinstalled the Spitfire and installed instead the first Acusim from when I purchased the Spitfire and now the new updater found the Spitfire and started to update it but the "an error to save file error downloading" occurred and Then update failed to down load was reported.
All the other planes were found and processed.
Hope you have got some more ideas.

Kindest regards
Paul

Re: Problem with the new Accsim update with the Spitfire

Posted: 25 Jul 2014, 23:55
by birdie33
Thanks Guys,
The latest Spitfire installer worked fine for me.
Thanks for your help

Regards
Paul :D