Page 2 of 2
Re: starting with out hand proping??
Posted: 26 Apr 2018, 15:45
by Tomas Linnet
I’ll test asap, but free time is limited at the moment...
Re: starting with out hand proping??
Posted: 27 Apr 2018, 05:21
by cessna lover
Tomas Linnet wrote:I’ll test asap, but free time is limited at the moment...
if you have the switch panel like me. you should see what I am talking about. I know the cub does not have an electric starter. because the cub does not have any power. but the switch panel make the plane use the auto start.
Re: starting with out hand proping??
Posted: 27 Apr 2018, 08:00
by Lewis - A2A
Hello,
what are you using to map the hardware?
Are you using SPAD etc?
thanks,
Lewis
Re: starting with out hand proping??
Posted: 27 Apr 2018, 10:13
by cessna lover
Lewis - A2A wrote:Hello,
what are you using to map the hardware?
Are you using SPAD etc?
thanks,
Lewis
no sir I don't use any of that. just the drivers for the switch panel.
Re: starting with out hand proping??
Posted: 28 Apr 2018, 08:53
by Lewis - A2A
that might be the issue, I seem to recall SPAD or some of the advanced software was a requirement for the Saitek stuff with more advanced simulations.
thanks,
Lewis
Re: starting with out hand proping??
Posted: 29 Apr 2018, 06:50
by cessna lover
ok. but I don't understand why just the cub would do this and not all my A2A planes that have auto start?