Page 1 of 1

p3d v3 installers

Posted: 16 Nov 2016, 22:22
by Dental1
Hi
I just purchased the piper accusim bundle in hopes of finding the p3d v3 installer I read about in mutlys post. Does one realy exist? Did I just waste my money?
Please help
thx Lee :(

Re: p3d v3 installers

Posted: 18 Nov 2016, 14:07
by Dental1
Is there actually nobody in the forum who knows of p3d installers for the piper cub? :? Wow

Re: p3d v3 installers

Posted: 18 Nov 2016, 15:11
by Mazo
There are no P3D installers at all -- BUT the Cub will install into P3D if you either copy and paste a copy of FSX.exe or copy the P3D.exe and rename it to FSX.exe. Place this file into your main P3D installation folder. Then you can point the Cub installer to your P3DV3 installation and it will install. The same goes for the Cub Accu-Sim, if you have purchased that.
Then get the latest Accu-Sim updater, http://www.a2asimulations.com/downloads ... _09_16.zip

Hope this helps.

Re: p3d v3 installers

Posted: 18 Nov 2016, 16:57
by Dental1
Thank you for your response. I guess I misunderstood the Facebook post on a2a Facebook page announcing p3d installers.
Thx again! Lee

Re: p3d v3 installers

Posted: 05 Jan 2018, 20:52
by Old Airman
I had no problem installing the Cub in P3d V3----but the engine runs for a few seconds, the propeller stops and the sound stops a few seconds later.

I haven't figured this out yet (and at my level of skill I probably won't!)

Rather disappointing as the A2A J-3 is my favorite bird.

Old Airman

Re: p3d v3 installers

Posted: 06 Jan 2018, 16:47
by mylee2
Follow Lyn's instruction's and you are to go.......................


Dick