I have seen where many people are using the Cub in P3D. I do realize this is not officially supported but if someone could give me some unofficial idea on how to do this. I have the desire to do some ski and float flying and feel settling for anything other than A2A would just be settling
I would gladly wait for an official version of this (and the other A2A products) if I knew they were in the works.
Any insight or direction is appreciated
Cub in P3D
Re: Cub in P3D
Hi Brett,
A2A Piper J-3 Cub is not officially supported in P3D. That being said, you can check the post from "bladerunner900" here:
http://a2asimulations.com/forum/viewtop ... arbird+p3d
Hope the tip is helpful.
Cheerz,
Will
A2A Piper J-3 Cub is not officially supported in P3D. That being said, you can check the post from "bladerunner900" here:
http://a2asimulations.com/forum/viewtop ... arbird+p3d
Hope the tip is helpful.
Cheerz,
Will
Bonanza, Skylane, Skyhawk, Cherokee, Cub, Texan, Mustang, Warhawk, Spitfire, Flying Fortress
Re: Cub in P3D
Thanks Will,
That is what I ended up doing. I have been enjoying flying the cub this weekend. Sometimes it is nice to get back to basics and just have some fun
That is what I ended up doing. I have been enjoying flying the cub this weekend. Sometimes it is nice to get back to basics and just have some fun
Who is online
Users browsing this forum: No registered users and 10 guests