The A2A Simulations Community

I have accu-sim installed for it. I read the manual, searched the manual and all I can figure out is I guess I have to use the pop-up menu and click on auto-start?

You have to change views to the hand start view (looking from the right to the nose and propeller). There you can grab the propeller blase with the mouse (clickspot on propeller blade). So you can pull it down. with fuel on, throttle cracked and primer depending on OAT, this will take some attempts.

Hi Paul - you could have a look at this video too.

Nick

Thanks, got it now. I like it! Very good.

I know I have to hand prop the J3. What function do I use so that I can grab the prop with the mouse?
Thanks

Press the left mouse button and hold it while you swing the prop.

Cheers Chris

Ok figured that but what from what view? From the cockpit view? When I left click on the prop from the cockpit view it doesn't grab it

click A in cockpit view until you get to the prop view.Look at the video included in this thread.

Please read the manual.

Cheers Chris

Thanks Chris I got it. When reading the manual I didn't see that you had to click through A until you got to the proper position.

You can also use the paddle to move around on the water.

Please take Heidi fun for a ride,you will love her reactions to your flying.

Cheers Chris

Thanks I'll do that