Hello,
since i apply the upgrade the cub in its tundra version doesn't run. Despite the CTRL+E the engine stop after some seconds. I precise thta the cub in in the other version run perferctly. Could you help me ?
Problem with the tundra version
Re: Problem with the tundra version
Hi,
Check the obvious - that you have fuel.
Next, I presume you have the AccuSim version? If so, check the mags are ON (left wing root), the fuel lever is forward (by your left knee).
Prime the engine (knob on the left side IIRC) - prime 3 times, then switch views to the outside prop view and just drag it until the engine starts.
Does it run now?
If not, go into the maintenance hangar and overhaul the engine. Try it again.
Ensure also that AUTO MIXTURE in FS OPTIONS is DISABLED!
Best regards,
Robin.
Check the obvious - that you have fuel.
Next, I presume you have the AccuSim version? If so, check the mags are ON (left wing root), the fuel lever is forward (by your left knee).
Prime the engine (knob on the left side IIRC) - prime 3 times, then switch views to the outside prop view and just drag it until the engine starts.
Does it run now?
If not, go into the maintenance hangar and overhaul the engine. Try it again.
Ensure also that AUTO MIXTURE in FS OPTIONS is DISABLED!
Best regards,
Robin.
A2A/AccuSim. 'nuff said!
Who is online
Users browsing this forum: No registered users and 18 guests