Just Flight's Constellation L049 & C69 for FSX only

[wingclip]

NOTE: It's likely that the 2 Aircraft config files, (Aircraft.cfg and Aircraft_.cfg), in the L049 and C69 folders are identical when it comes to the light and engine configs but I did not check to make sure.

That's why I have listed the Shockwave edits for each. Also, be sure to replace the data that's under the "General Engine Data" section with the the changes I made to the first 5 lines at least. But it's just easier and quicker to replace the entire section with the one I supplied. Without that, the flames, (that come out from the exhaust pipe on both sides of each engine when they are over-throttled), will not be in the right position.

They're pretty good and work for both, the "Speedpack" and Normal L049 and C69 FSX Planes. ALWAYS BACKUP UP YOUR ORIGINALS!


Replace the Lights & exhaust effects in the "Aircrat.cfg" File with the section below:

[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing 6=taxi, 7=recognition, 8=wing, 9=logo
light.0 = 3, -5.40, -62.62, 5.25, fx_shockwave_navred.fx
light.1 = 3, -5.40, 62.62, 5.25, fx_shockwave_navgre.fx
light.2 = 3, -59.00, 0.00, 6.50, fx_shockwave_navwhi_l.fx
light.3 = 1, -7.485, 0.00, 8.4, fx_shockwave_beacon_rotating_red.fx
light.4 = 1, -12.50, 0.00, -4.40, fx_shockwave_beacon_rotating_red.fx
light.5 = 4, 27.75, 0.00, 3.00, fx_shockwave_vclight.fx
light.6 = 5, 31.00, 0.00, -6.50, fx_shockwave_landing_light.fx

// exhaust effects
light.7 = 6, 6.50, -30.30, -3.30, FX_JF_L049_HP_Flame,; engine 1
light.8 = 6, 6.50, -31.80, -2.30, Fx_JF_Connie_Smoke ;#1 Left
light.9 = 6, 6.50, -28.80, -2.30, Fx_JF_Connie_Smoke ;#1 Right
light.10 = 7, 8.0, -14.10, -5.07, FX_JF_L049_HP_Flame ; engine 2
light.11 = 7, 8.0, -15.60, -4.07, Fx_JF_Connie_Smoke ;#2 Left
light.12 = 7, 8.0, -12.60, -4.07, Fx_JF_Connie_Smoke ;#2 Right
light.13 = 8, 8.0, 14.10, -5.07, FX_JF_L049_HP_Flame ; engine 3
light.14 = 8, 8.0, 12.60, -4.07, Fx_JF_Connie_Smoke ;#3 Left
light.15 = 8, 8.0, 15.60, -4.07, Fx_JF_Connie_Smoke ;#3 Right
light.16 = 9, 6.50, 30.30, -3.30, FX_JF_L049_HP_Flame,; engine 4
light.17 = 9, 6.50, 28.80, -2.30, Fx_JF_Connie_Smoke ;#4 Left
light.18 = 9, 6.50, 31.80, -2.30, Fx_JF_Connie_Smoke ;#4 Right


Then go to "[GeneralEngineData]" section, (in the same Aircraft.cfg file) and replace that entire section with this:

engine_type = 0
Engine.0 = 6.5, -30.20, -3.334
Engine.1 = 8.0, -14.00, -5.07
Engine.2 = 8.0, 14.000, -5.07
Engine.3 = 6.5, 30.20, -3.334
fuel_flow_scalar = 1
min_throttle_limit = -0.25
master_ignition_switch = 0
max_contrail_temperature = -39
thrustanglepitchheading.0 = 0, 0
thrustanglepitchheading.1 = 0, 0
thrustanglepitchheading.2 = 0, 0
thrustanglepitchheading.3 = 0, 0



Replace the Lights & exhaust effects in the "Aircrat_.cfg" File with the section below:

[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing 6=taxi, 7=recognition, 8=wing, 9=logo
light.0 = 3, -5.40, -62.62, 5.25, fx_shockwave_navred.fx
light.1 = 3, -5.40, 62.62, 5.25, fx_shockwave_navgre.fx
light.2 = 3, -59.00, 0.00, 6.50, fx_shockwave_navwhi_l.fx
light.3 = 1, -7.485, 0.00, 8.4, fx_shockwave_beacon_rotating_red.fx
light.4 = 1, -12.50, 0.00, -4.40, fx_shockwave_beacon_rotating_red.fx
light.5 = 4, 27.75, 0.00, 3.00, fx_shockwave_vclight.fx
light.6 = 5, 31.00, 0.00, -6.50, fx_shockwave_landing_light.fx

// exhaust effects
light.7 = 6, 6.50, -30.30, -3.30, FX_JF_L049_HP_Flame,; engine 1
light.8 = 6, 6.50, -31.80, -2.30, Fx_JF_Connie_Smoke ;#1 Left
light.9 = 6, 6.50, -28.80, -2.30, Fx_JF_Connie_Smoke ;#1 Right
light.10 = 7, 8.0, -14.10, -5.07, FX_JF_L049_HP_Flame ; engine 2
light.11 = 7, 8.0, -15.60, -4.07, Fx_JF_Connie_Smoke ;#2 Left
light.12 = 7, 8.0, -12.60, -4.07, Fx_JF_Connie_Smoke ;#2 Right
light.13 = 8, 8.0, 14.10, -5.07, FX_JF_L049_HP_Flame ; engine 3
light.14 = 8, 8.0, 12.60, -4.07, Fx_JF_Connie_Smoke ;#3 Left
light.15 = 8, 8.0, 15.60, -4.07, Fx_JF_Connie_Smoke ;#3 Right
light.16 = 9, 6.50, 30.30, -3.30, FX_JF_L049_HP_Flame,; engine 4
light.17 = 9, 6.50, 28.80, -2.30, Fx_JF_Connie_Smoke ;#4 Left
light.18 = 9, 6.50, 31.80, -2.30, Fx_JF_Connie_Smoke ;#4 Right

Then go to "[GeneralEngineData]" section, (in the same Aircraft_.cfg file) and replace that entire section with this:

engine_type = 0
Engine.0 = 6.5, -30.20, -3.334
Engine.1 = 8.0, -14.00, -5.07
Engine.2 = 8.0, 14.000, -5.07
Engine.3 = 6.5, 30.20, -3.334
fuel_flow_scalar = 1
min_throttle_limit = -0.25
master_ignition_switch = 0
max_contrail_temperature = -39
thrustanglepitchheading.0 = 0, 0
thrustanglepitchheading.1 = 0, 0
thrustanglepitchheading.2 = 0, 0
thrustanglepitchheading.3 = 0, 0


Then go to the L049 & C69 "Panel" file and insert the line below as the last line, (under gauge 11), in the "VC Cockpit01" section:

gauge12=shockwave_lights!SW Lights_gear, 1,1,1,1 //shockwave light

wingclip
BTW, thanks to you all for some great lights I get from this site!