The A2A Simulations Community

I'm happy with this setup. Due to wing flex, I got rid of the white lights on the trailing edge of the wing tips -- there is a little one there anyway somehow. The strobe also gave me trouble with wing flex, but it is "fuzzy" enough I can put it a bit above on the ground, and it looks fine in the air.

I left the taxi lights as they were because I didn't think adding them to the shockwave double landing lights just below looked better; if anything it was too much of a good thing. The landing lights on the wing I put at narrow to avoid the band effect.

landing_light_light sounds interesting, but I don't have a clue where to begin.

Any suggestions appreciated.

[LIGHTS]
light.0 = 1, 0.70, 0.00, -3.90, fx_shockwave_beaconb
light.1 = 1, 40.00, 0.30, 10.57, fx_shockwave_beaconh_nl
light.2 = 4, 67.00, 2.00, 5.19, fx_shockwave_vclight
light.3 = 4, 67.00, -2.00, 5.19, fx_shockwave_vclight
light.4 = 5, 15.35, 7.35, 0.10, fx_shockwave_landing_light_narrow
light.5 = 5, 15.35, -7.35, 0.10, fx_shockwave_landing_light_narrow
light.6 = 7, -17.00, -55.00, 2.50, fx_shockwave_navred
light.7 = 7, -17.00, 55.00, 2.50, fx_shockwave_navgre
light.8 = 2, -19.00, -61.50, 7.00, fx_shockwave_strobe_l
light.9 = 2, -19.00, 61.50, 7.00, fx_shockwave_strobe_l
light.10 = 8, 13.40, -17.47, 3.40, cs757_edge
light.11 = 8, 13.40, 17.47, 3.40, cs757_edge
light.12 = 5, 58.50, 0.00, -5.50, fx_shockwave_landing_light_double
//light.13 = 5, 70.50, 0.00, 10.50, fx_shockwave_landing_light_light work in progress

Problem: landing lights are on both nose gear and wings. When the nose gear goes up, the lights turn off -- all of them, including the ones on the wing. Is there any way to limit the "lights out" panel line to the nose gear only and leave the wing landing lights alone? I can't even turn them back on while the nose gear is up, because the switch snaps back almost before I can switch to spot to see the wing landing lights very briefly before they switch off.

u must install the shockwave gauge in the panel.cfg and alter de "lights"line:
gaugeXX=shockwave_lights!SW SW Lights_Taxi_gear, 1,1,1,1 //shockwave light

in the aircraft.cfg
taxi=6
light.12 = 5, 58.50, 0.00, -5.50, fx_shockwave_landing_light_double
then becomes:
light.12 = 6, 58.50, 0.00, -5.50, fx_shockwave_landing_light_double

_________________
anything that moves, moves me