The A2A Simulations Community

"Come share your passion for flight"
It is currently Wed May 22, 2013 10:51 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Aug 30, 2005 3:39 pm 
Offline
BDG

Joined: Wed Aug 24, 2005 12:14 pm
Posts: 1277
Location: Was "CPS_Bomber"
~S~ guys!

Check out the trim wheels in the Hurricane cockpit. As they turn, they change size....they get very, very small, then suddenly get bigger again, then smaller.....

Haven't checked in any other aircraft as yet, but maybe worth doing so just in case they're all suffering this effect.

<EDIT UPDATE>

OK, just done some fiddling in the other aircraft.


The Hurricane, as stated above, the trim wheels grow & shrink as they turn.

The Spitfire is fine, as it the Ju-87.

The Me109 and Me110 have some very odd trim levers / wheels animation - I wonder of they're not calibrated properly with neutral trim settings?

For example, in the Me110, the rudder trim lever starts off positioned way over to the right (yet it's neutral trim). When you add right trim, the lever doesn't do anything for a few seconds, then suddenly jumps and appears over to the far left and then continues to slide to the right, back towards the center of the trim guide (that curved white strip).

The pitch trim wheel & guide on the Me110 has the same behaviour, but along the horizontal slider as shown in the cockpit. It starts off in a non-neutral position (despite being neutral trim) and does the same jumping about from one end of the guide to the other. What makes this more noticable, is the large blue trim wheel with the writing on - it looks like it flips upside down.

The Me109 has a graphics glitch with the reflections & shading on the trim wheel as well as the odd jumping effect and possible off neutral starting position (again the actual trim is neutral). It looks like it also suddenly flips upside down because of the extreme dark/light shading on the wheel.

I've tested the trim controls using keyboard and sliders on the HOTAS stick setup I have, plus different deadzone, filters etc as found in the in game config options for the various stick axis. All with the same results.

As a thought for something way in the future, would it be possible to animate the external control surfaces to show the trim settings in use?

Cheers!
Rob

aka CPS_Bomber

_________________
Vista Home Prem 32bit(SP2)Dx11
Intel Core2 Quad Q6600@2.40GHz, 3GB RAM, GeForce 9500GT 2303MB total, Realtek HD Audio, 300GB+700GB H/disk, Saitek X-52pro, ProPedals, Throttle Quad, Pro Command Unit x2, VRI T&T Panel, HannsG 19" w/s monitor.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: Bing [Bot] and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group