Page 1 of 1
default garmin 400 issue
Posted: 20 Sep 2018, 10:08
by alan CXA651
Hi.
On the default garmin 400 the push crsr button does not operate in the vc for selection when scrolling down the flight plan , but does in the 2d popup.
regards alan.
Re: default garmin 400 issue
Posted: 21 Sep 2018, 23:03
by MrMe85
Also share the same issue.
VNAV button also does not work. Prefer the old procedures button.
Re: default garmin 400 issue
Posted: 22 Sep 2018, 08:48
by Nick - A2A
Thank you for the reports guys. We will look into this issue.
Cheers,
Nick
Re: default garmin 400 issue
Posted: 22 Sep 2018, 10:14
by MrMe85
While you are at it, the GPS 295 quit button also does not work.
Re: default garmin 400 issue
Posted: 28 Sep 2018, 02:01
by Tomas Linnet
Re: default garmin 400 issue
Posted: 28 Sep 2018, 05:02
by Nick - A2A
Will do Tomas. Sorry, I missed this one originally as posts in the tech support forum tend to take priority.
Thanks,
Nick
Re: default garmin 400 issue
Posted: 28 Sep 2018, 05:15
by Tomas Linnet
Nick - A2A wrote:Will do Tomas. Sorry, I missed this one originally as posts in the tech support forum tend to take priority.
Thanks,
Nick
not a problem Nick, I only realised I posted in the "V-Tail" forum when I searched to find a link
Re: default garmin 400 issue
Posted: 29 Sep 2018, 05:12
by Tomas Linnet
update:
when using the 2D default GNS400 everything seems to be back to normal. I just noticed when reading this :
http://www.a2asimulations.com/forum/vie ... 38&t=65879