Dear Support,
I have a problem with the l-049 input configurator. In that any axes or button I set has no effect within the sim.
I'm using P3d v3.4. I'm trying to set the nosewheel steering & the RPM switch.
I've tried running the config program as administrator, no joy.
Help appreciated in advance,
James
Input Configurator
- Nick - A2A
- A2A Captain
- Posts: 13777
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Input Configurator
Hi James,
Do you use FSUIPC? If so, you'll need to make sure the "enable controller(s)" tick box is ticked in order to use the Comanche Input Configurator. This basically means you'll need to delete hardware axis assignments etc. in the P3D control setting if you assign them using FSUIPC instead.
Thanks,
Nick
Do you use FSUIPC? If so, you'll need to make sure the "enable controller(s)" tick box is ticked in order to use the Comanche Input Configurator. This basically means you'll need to delete hardware axis assignments etc. in the P3D control setting if you assign them using FSUIPC instead.
Thanks,
Nick
- Nick - A2A
- A2A Captain
- Posts: 13777
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Input Configurator
Sounds like that might be the culprit! I meant "L-049 Input Configurator" above of course.
Nick
Nick
Re: Input Configurator
Yes Nick, thanks very much.
Though I did have to spend a few minutes chasing down phantom control assignments!
Though I did have to spend a few minutes chasing down phantom control assignments!
Who is online
Users browsing this forum: No registered users and 17 guests