Hey,what is L:ApElevatorRemoteControl for? Is that a Boolean control or variable? The AP remote is just referring to the knob on the panel instead of the large white trim wheel isn't it? Also the Lvar
L:ApElevatorSpeed is for the elevator servo speed but is that modeled? I have played with that control on the panel several times and it doesn't seem to do anything. I would think that that would be the control to adjust to reduce the elevator from putting in so much "up" when the plane enters a bank, is that correct? I seem to remember something similar on the B-17 that worked amazingly well but I don't own that plane for P3D?
What is this Lvar for?
What is this Lvar for?
Thanks Mark
Re: What is this Lvar for?
ApElevatorRemoteControl variable is not used at the moment. The "Ap" prefix refers to an autopilot.
regards
ROB
regards
ROB
A2A Simulations Inc.
Who is online
Users browsing this forum: No registered users and 10 guests