What is this Lvar for?

[n454mw]

Hey,what is L:ApElevatorRemoteControl for? Is that a Boolean control or variable? The AP remote is just referring to the knob on the panel instead of the large white trim wheel isn't it? Also the Lvar
L:ApElevatorSpeed is for the elevator servo speed but is that modeled? I have played with that control on the panel several times and it doesn't seem to do anything. I would think that that would be the control to adjust to reduce the elevator from putting in so much "up" when the plane enters a bank, is that correct? I seem to remember something similar on the B-17 that worked amazingly well but I don't own that plane for P3D?

[ROB - A2A]

ApElevatorRemoteControl variable is not used at the moment. The "Ap" prefix refers to an autopilot.

regards
ROB