The problem is that my Connie cannot move an inch after update.
Engines are working with full power but RPM do not increase.
I have restarted Connie 3 times but problem remains.
Before update i had no such problem.
Problem after last patch
Re: Problem after last patch
Hey Artur, check and make sure the RPM increase/decrease switch is in the neutral position and not down.
John.
John.
Cub. Cherokee. C182. Comanche 250. Spitfire. T-6. B-17. B377. Connie
Re: Problem after last patch
Hmm... did not notice that - thanks a lot
Last edited by Artur on 21 Mar 2017, 05:19, edited 1 time in total.
Re: Problem after last patch
No worries, you're welcome. Sshhhhhhh......it happened to me too
Cub. Cherokee. C182. Comanche 250. Spitfire. T-6. B-17. B377. Connie
Re: Problem after last patch
Yep, before it was not like that...
-
- Technical Sergeant
- Posts: 509
- Joined: 25 May 2013, 08:50
- Location: KBOS
Re: Problem after last patch
Has the patch been fixed yet. I see a lot of people posting problems.
- CAPFlyer
- A2A Aviation Consultant
- Posts: 2241
- Joined: 03 Mar 2008, 12:06
- Location: Wichita Falls, Texas, USA
Re: Problem after last patch
Most of the problems brought up are in individual installations and have been unable to be recreated on any of the BETA tester's systems or were due to factors outside the patch (i.e. the LINDA module, or other software that "lost configuration" after the update).
Who is online
Users browsing this forum: No registered users and 9 guests