Engine start up

[david1952]

Is your settings as set in the manual for the simulation?

thanks
Lewis

Didn't change nothing from last time I flied.

Bye, David

[alan CXA651]

Hi.
The RPM will fluctuate slightly , but how much is yours fluctuating by, and is this on all engines , and at all RPM`s , or at low RPM`s only .
Idle RPM should be 1000 to 1200 when cold , also once engines warm does the fluctuation settle down.
And is there any other gauge annomallies for the engines;
Regards alan.

[david1952]

Hi.
The RPM will fluctuate slightly , but how much is yours fluctuating by, and is this on all engines , and at all RPM`s , or at low RPM`s only .
Idle RPM should be 1000 to 1200 when cold , also once engines warm does the fluctuation settle down.
And is there any other gauge annomallies for the engines;
Regards alan.

I really use the "ready for takeoff" lately.
When the Connie is loaded, the engines are running and RPM starts getting crazy on all 4 engines after a few seconds.
If I can show it on video it will be much clearer.

Thanks, David