The A2A Simulations Community

I am doing repeated 25 - 35 knot crosswind landing practice in the T-6 and would like to
NOT have to continue to remember to shift-4 damage off or go to the maintenance hanger.
Is there a way to permanently configure damage On-Off?

Thanks

tttt wrote:I am doing repeated 25 - 35 knot crosswind landing practice in the T-6 and would like to
NOT have to continue to remember to shift-4 damage off or go to the maintenance hanger.
Is there a way to permanently configure damage On-Off?

Thanks

You are most likely exceeding the crosswind component of that aircraft.

bobsk8 wrote:

tttt wrote:I am doing repeated 25 - 35 knot crosswind landing practice in the T-6 and would like to
NOT have to continue to remember to shift-4 damage off or go to the maintenance hanger.
Is there a way to permanently configure damage On-Off?

Thanks

You are most likely exceeding the crosswind component of that aircraft.

When you are in an emergency you can't choose eather.. ^^

Hi,

I believe, you can disable plane crashes from the sim itself and you can practice those dangerous crosswind landings without any worries of damage.

Cheerz,
Will

They know how to turn it off, but they are asking if the damage setting can be locked on/off.

As far as I know, the answer is no.

Hello,

if its all in one flight, just hit damage OFF in shift + 3 panel.

thanks,
Lewis

The original post should have said Shift 3 (NOT shift 4) and the maintenance hangar.
A crash wipes out the damage-off setting when FSX automatically resumes after a crash,
which can occur fairly often in this practice, so if don't remember Shift 3, next time the
maintenance hangar. Would be better if damage was a permanent toggle on/off till the
user decides differently.
Thanks,
tttt

Oh right, in that case as others say then, you'd be looking to turn damage off in fsx itself re-crash detection.

thanks,
Lewis