Hello all,
I would like to assign the " attidude pitch trim " to a rotary encoder ( VRi multi switch panel ), but I do not find that lvar;
all the other buttons, switches and axes are working fine, as I found them in the A2A Comanche variable list.
Is there an lvar for that function?
BTW: I do not use LINDA
Thanks for any input and best regards
Chris
Assigning Attitude Pitch Trim
- Nick - A2A
- A2A Captain
- Posts: 13808
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Assigning Attitude Pitch Trim
Hello Chris,
I don't think there's a custom L:Var you need to use for the elevator trim crank. Instead, you could try using the x0BC0 offset in FSUIPC. For instance, here's an example of how this offset can be used with the SWORD increment/decrement method. You can adjust the figure before the "/" in the "parameter" value to tune the amount that the trim crank moves with each notch of your rotary encoder.
Cheers,
Nick
I don't think there's a custom L:Var you need to use for the elevator trim crank. Instead, you could try using the x0BC0 offset in FSUIPC. For instance, here's an example of how this offset can be used with the SWORD increment/decrement method. You can adjust the figure before the "/" in the "parameter" value to tune the amount that the trim crank moves with each notch of your rotary encoder.
Cheers,
Nick
-
- Airman Basic
- Posts: 4
- Joined: 20 Apr 2017, 15:36
Re: Assigning Attitude Pitch Trim
Hey Chris,
Did you ever get a resolution on this? I'm trying to do the same thing.
Did you ever get a resolution on this? I'm trying to do the same thing.
Who is online
Users browsing this forum: No registered users and 28 guests