When I resume a saved flight, I have major problems when turning the altitude hold switch back on. The AP switch is already on I have to reset the HDG switch but once I reset the altitude switch the aircraft dives and rises dramatically whilst I frantically trim up and down trying to get back to level flight. Today i ended up 3000 feet above my last saved altitude and the aircraft also kept turning in circles even though the heading was on auto pilot. When resuming a saved flight I always load the default flight first, end the scenario and then load my saved flight.
I am flying with P3D V4.1
Richard
Saved Flights
- Nick - A2A
- A2A Captain
- Posts: 13801
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Saved Flights
Hello Richard,
In this case, you could try loading the default flight, then selecting the Comanche from the 'vehicle' menu, and finally loading your saved flight. It may also be worth saving flights with the autopilot master in the off position if you're experiencing odd behaviour.
Thanks,
Nick
In this case, you could try loading the default flight, then selecting the Comanche from the 'vehicle' menu, and finally loading your saved flight. It may also be worth saving flights with the autopilot master in the off position if you're experiencing odd behaviour.
Thanks,
Nick
Who is online
Users browsing this forum: No registered users and 14 guests