F1 GTN750 NOT INSTALLING INTO THE C182

[mickp]

I used the A2A aircraft config file with no warning to the contrary it appeared to accept my F1 selection and saved.

Launched p3d v3 loaded C182 I then opened shift 3 window to implement the GTN750, it was not displayed as an option just the default GPS.

Any idea if this can be loaded through code or does this require a re-install any thoughts or remedy for this would be really appreciated.

Putting the GTN750 into the Duke was an absolute breeze, expected better from A2A.

[n421nj]

Did you check your antivirus to make sure it wasnt blocked?

[bobsk8]

Did you run the configurator as admin?

[mickp]

Problem solved, the c182 required the update although that didn't go smoothly as the install would fail, error message: said it was looking for bitmap5 from an airbus model, thanks to this forum I deleted that airplane folder and voila I now have the GTN750 installed in the c182.

Thanks for your help.

[Lewis - A2A]

Good to hear you are up and flying it sounds like you where not running as admin or you have a custom directory for your P3D or both.

thanks,
Lewis