Can`t start the engine !

[GunnarM]

Hi.
Iam using P3D v3.49 and have SpadNext installed to controll my Saitek yoke and pedals and instrument panels.
My problem is that i can not start the engine with my Saitek and i have followed the manual.
And i have the same problems when i try to start with the keyboard. CTRL+E
I can se the i have power i can hear the fuelpump but i cant get the engine to turn a round.
I have allso tryed to reinstall the aircraft.
I have been looking in the manual to see if there was anything there to find the solution.

So now i hope you can assist me with some god adwise .

best regards

[Lewis - A2A]

Hello and welcome to the forums.

First thing to ask and check is if you are all updated with the latest Accu-sim updater?

Next up that the aircraft is fit for flight all good in the pre-flight walkaround, all liquids in correctly in the load manager and all good in the maintenance hangar?

thanks,
Lewis - A2A

[GunnarM]

Hi. Thanks it works just fine.

Best regards

[Lewis - A2A]

Hello, good to hear, happy flying

thanks,
Lewis