Takeoff in Courchevel LFLJ causes propeller damage

[Raller]

Hello,
the Runway in Courchevel LFLJ has a gradient of up to 18.66%. I use the addon from LLH "COURCHEVEL ALTIPORT" in my P3D v3.3.5.

When i try to takeoff with the Piper Cherokee 180 it always causes a propeller damage on the runway and the engine stops. I guess it is because of the runway-angle of up to 16,5 degrees and at that angle the aircraft suspects an propeller-ground-hit!

Is that true and is it possible to fix the problem somewhere in the aircraft.cfg?

It happend only with the Cherokee 180, no matter what kind of "Damage" or "Realistic" settings i use.

Kind regards
Raller

[Lewis - A2A]

Shift + 3 you could turn damage OFF until in the air.

thanks,
Lewis

[Raller]

Hi Lewis,
like i said, no difference if "Damage" is ON or OFF. Right after the Plane goes over the Hilltop, the Engine stutters and stops (see screenshots).

[TreeTops]

The Cherokee suffers prop damage on any uneven surface. Orbx Papua TIP Scenery is the same and has been reported previously.

[Raller]

Hi Trev,

thank you for your advice, that's what I had feared. I'm so sad that i can't takeoff at this Airport with my lovely Cherokee (by the way, one of the best Airplanes in my collection).

@Lewis: Is there no workaround or update to get the "Damage ON/OFF" setting work like it should and turns the prop-damage-detection off?

That's only a little drop of bitterness. The A2A-Team did an outstanding job in the technical implementation of the Piper 180...


Thx and greetings from Germany
Raller