PIPER 180 FAILURES
PIPER 180 FAILURES
When I open P3DV4 with the PIPER 180, in the VEHICLE/FAILURES, it always shows the radio failed which means the ATC menu is inop. I reset the failure, the ATC MENU is op. The issue I am having is EVERY time when I again start up P3DV4, it again shows the radio has failed...The previous time I reset the radio failure, so do i have to check the VEHICLE/FAILURES every time? It doesn't seem like i should have to. Not a real big deal, your thoughts on this?
- Nick - A2A
- A2A Captain
- Posts: 13804
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: PIPER 180 FAILURES
Hello Steve,
This is still with the GTN 750 right?
If so, please can you try the following:
1. Use the Shift 3 panel to set the cockpit back to the "NO GPS" state.
2. Make sure the default radios are both switched on using the power switch at bottom left.
3. Switch back to the GTN 750 using the Shift 3 panel.
Thanks,
Nick
This is still with the GTN 750 right?
If so, please can you try the following:
1. Use the Shift 3 panel to set the cockpit back to the "NO GPS" state.
2. Make sure the default radios are both switched on using the power switch at bottom left.
3. Switch back to the GTN 750 using the Shift 3 panel.
Thanks,
Nick
Re: PIPER 180 FAILURES
The Garmin 750 is working fine..the issue is the VEHICLE/FAILURES always shows to fail the radios every time i start up P3DV4..every time i have to reset in the Failures for the ATC to be working correctly..and this is only with the Piper 180
- Nick - A2A
- A2A Captain
- Posts: 13804
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: PIPER 180 FAILURES
I understand, but please try the steps I suggested above.
Thanks,
Nick
Thanks,
Nick
Re: PIPER 180 FAILURES
NICK, You did it again..My issue with the Piper 180 ATC menu and radio failure is resolved. Thank you for your support once again. Steve
- Nick - A2A
- A2A Captain
- Posts: 13804
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: PIPER 180 FAILURES
You're welcome Steve. Thanks for posting with the update.
Nick
Nick
Who is online
Users browsing this forum: No registered users and 31 guests